Note:
1. Onboard VTX can only work when battery was plug. And low power of vtx when disarmed was actived. So the vtx is very lower nearly 0 power out when drone was not armed, you can change power level value.
2. Visit https://app.betaflight.com and click “select your device” then choose can’t find my USB device, then connect comport and betaflight configurator.
3. Due to firmware target is not available in current betaflight official ,you can download hex file from the belowing link:Firmware download CRAZYG473 4.6.0 betaflight firmwareDefault factory dump file Dump file for CRAZYG473 Betaflight4.6.0
Specification:
Brand: Happymodel
Model: CrazyG473 V1.0 AIO 5-IN-1 Flight Controller
|
Item |
Parameter |
|
FC |
MCU: STM32G473CEU6 Gyro: ICM42688P Blackbox memory: 16MB Sensor: Voltage & Current BEC: 5V, Max. 2A UART: UART 1, UART 2, UART 3 (For RX), UART 4(For VTX) BetaFlight OSD: AT7456E ESC: 5A continuous RX: Serial ELRS 2.4GHz RX antenna: Enameled copper wire 31mm length Receiver firmware target: HappyModel EP1/EP2 2.4GHz RX OPENVTX: 5.8GHz 48 channels, Max. 400mW FC firmware target: CRAZYBEEG473 USB port: SH1.0-4Pin Battery connector: A30 Mounting hole x 25.5mm Weight: 83g without pigtail and vtx antenna |
|
ESC |
Power input: 1S Only Current: 5A continuous, 6A peak ESC firmware: V0.21.hex Bluejay Firmware target: A_X_5_96KHz Digital signal protocol: DShot300, DShot600 |
|
VTX |
– OPENVTX Firmware – Support firmware upgrade by openvtx configurator Output power: PIT/10/25/100/400 Frequency: 5.8GHz 48 channels, with Raceband: 5658~5917MHz Channel SEL: SmartAudio2.1 Modulation type: FM Operating temperature: -10℃~+80℃ Antenna port: IPEX1/U.FL |
Package Included:
1 x CrazyG473 V1.0 AIO
‘Times New Roman’;12.0000pt;1.0000pt;















There are no reviews yet.