Happymodel SuperX HD ELRS 1-2S AIO Flight Controlelr Built-in 12A ESC and UART ELRS Receiver for Digital Whoop RC Drone FPV Racing

Flight controller

SuperX HD ELRS

0.0000pt;Betaflight 4.4.2 firmware ready

0.0000pt;Firmware 0.0000pt;CRAZYBEEF4DX
0.0000pt;MCU:STM32F411CEU6 (100MHz0.0000pt;, 512K FLASH)
0.0000pt;SBMI270 or ICM42688P 0.0000pt;(SPI connection)
0.0000pt;Power 1-2S Lipo Lihv0.0000pt; battery input (DC 0.0000pt;2.8V~8.70.0000pt;V)0.0000pt;, 7.5000pt;0.0000pt;only support 1s input for this drone
0.0000pt;Built-in 0.0000pt;120.0000pt;A(each) Blheli_S 4in1 ESC Dshot30.0000pt;00 read

0.0000pt;Built-in UART elrs receiver , elrs v3.0 ready, support WIFI and pass-through firmware update

0.0000pt;Bluejay ESC Firmware ready
0.0000pt;Built-in 5V 10.0000pt;A B0.0000pt;EC
0.0000pt;Built-in voltage detection

0.0000pt;No betaflight analog osd chip

Onboard 4in1 ESC

0.0000pt;Power 1-20.0000pt;S LiPo/LiPo HV

0.0000pt;C120.0000pt;A continuous peak 0.0000pt;150.0000pt;A (30.0000pt; seconds)
0.0000pt;Support 0.0000pt;ESC-Configurator and BLHELI_S Suite configurator
0.0000pt;Factory Z-H-30 – Bluejay, 0.19, 48kHz
0.0000pt;Default protocol: DSHOT30.0000pt;00

Onboard UART ExpressLRS 2.4GHz Receiver

0.0000pt;RF Frequency: 2.4GHz

0.0000pt;Antenna: enameled copper wire 31mm length
0.0000pt;Telemetry output Power: <12dBm
0.0000pt;Receiver CRSF
0.0000pt;Default firmware version: ExpressLRS V3.0.1

0.0000pt;The same hardware with Happymodel EP1 receiver

0.0000pt;Could update firmware via ExpressLRS configurator or WIFI or Betaflight pass-through